How about inkjet cloth billboards without wrinkles?

Generally, after hanging it for a period of time, after the expansion and contraction due to heat and cold, the wrinkles will naturally disappear, and then the rope can be tightened a little more. Secondly, you can use water with a relatively high temperature to spray it, remember to spray it from the back. But to be honest, we usually just wait for it to naturally stretch a little, that is, hang it up first, and then tighten the rope a little after ten days and a half.

First stretch out the two opposite corners. Once the four corners are fixed, then move from the middle of the two long sides to both sides. Just don’t stretch the first long side hard enough to avoid missing the white edge. The remaining The long side is stretching, and the last two short sides are stretching. If there are a few small wrinkles, it’s okay. Just expose it to the sun for two days. I have been doing advertising for almost five years. I hope it is useful to you and you will adopt it!

If the inkjet advertising cloth is wrinkled, you can try the following methods to smooth it out:

Pour boiling water Pull up and flatten the back of the pleats (remember not to scald the front surface directly with boiling water, and be careful not to burn yourself), and blow hot air from a hair dryer if possible.

Be sure to use force when installing the scraper screen. If possible, use tools such as powerful pliers to install it.

If it is a light box screen, be sure to pull the edge of the screen hard to install and fix it. When the light is turned on, it is equivalent to heating the screen, and the screen will naturally become flat in a few days.